Automatic Restart; Adjusting The Air Flow - Domo DO-262A Manual De Instrucciones

after 30 min. After another 30 min the temperature will increase with another 1°C. The
airco will maintain this temperature for 7 hours. After this time, the airco will go back
to the original set temperature and the "sleep" function will end.
NOTE : this function can not be selected with the "fan" or "dry" function.

AUTOMATIC RESTART

When the airco will turn off unexpectely, because of a power failure, the unit will
turn back on when the power comes back on. All the settings will remain the same as
before the power failure.
NOTE : the unit can only restart after 3 min. So if the power failure is shorter than 3
min the unit will still take up to 3 min to restart.

ADJUSTING THE AIR FLOW

The airflow can be adjusted manually, by turning the ribs of the air outlet in the
desired direction.
INSTALLATION
Place the airco on a solid and stable floor, this way you will
prevent excessive noice and vibrations. Make sure that the floor
is strong enough to support the weight of the appliance.
The appliance has small wheels for easy moving. Make sure
only to move the airco over a flat and level surface. Be careful
when moving the airco over carpet. Never roll the unit over an
object.
Place the unit near an earthed socket.
Never place any object within 30 cm round the airco.
INSTALLATION OF THE WINDOW KIT
The air outlet hose must be used in the "cool" or "auto" mode. During the
"fan" or "dry" mode, you don't need to attache the air outlet hose.
- Place the round ring with small air outlet on the air outlet hose.
- Place the window kit in your window. This can be used horizon-
tally or vertically. Block the window kit on
the desired length, with the supplied bold.
- Use the window seal to close up any gaps
between the window and the window kit.
NOTE : Make sure the air outlet hose isn't bend during use.
Make sure there is a free surrounding of at least 50 cm around the
outlet.
59
DO-262A