Metz mecablitz 64 AF-1 digital Manual De Instrucciones página 172

automatic unit switch-off is shown in the
INFO display. The flash ready indicator
the indicators on the LC display disappear.
The
mode.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
the shutter release (wake-up function).
+
In slave-/ servo mode, the automatic cut-off
is not activated.
The flash unit should always be turned off
k using the main switch
to be used for an extended period!
If necessary, the Auto OFF function can be set
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use.
In all operating modes, the brightness of the
screen is reduced by 50 per cent after
approx. 10 seconds to save energy.
The screen brightness is restored again
whenever a button or a symbol on the screen
is pressed.
172
D
button flashes red in stand-by
D
button, or by tapping on
if it is not going
and
OPTION
O
OPTION
ZOOM MODE
STANDBY
MOD. LIGHT
p
q
O
STANDBY
OFF
1 min
10 min
Setting the automatic unit switch-off
• Switch on the flash unit with the
The start screen appears.
The flash unit always switches on after-
wards with the mode of operation that was
used last (e.g. manual flash mode M).
D
• Press the button as often as it takes
for the selection menu to appear.
OPTION
• Press the sensor button on the
touch display.
• Press the sensor buttons on the
STANDBY
touch display and select
STANDBY
• Press the sensor button on the
touch display.
• Tap the sensor button on the touch display
for the desired time. The setting is adopted
immediately.
D
The button flashes red in stand-by
mode.
button.
.