Locking / Unlocking; Connecting A Power Pack (Accessory) - Metz mecablitz 64 AF-1 digital Manual De Instrucciones

Acoustic signals after the flash unit has been
turned on:
• A short (about two seconds) uninterrupted
Set Beep signals when adjusting automatic
mode settings:
• A short beep signal as an alarm in auto-
k
204
beep signal after turning the flash on indi-
cates that the flash unit is ready.
matic mode indicates that the aperture and
ISO settings exceed the permissible light
control range. The auto aperture of the
mecablitz is then automatically adjusted to
the next permissible value.

11.10 Locking / unlocking

The setting on the flash unit can be locked
GN
against unintended changes.
To lock or unlock, hold down the
for approximately 3 seconds.
3.6m
On the screen, all the sensor buttons are
M-
5,6
m
35
Zoom F
m shown in white and can no longer be
EV
accessed.
Only the INFO sensor button can be pressed.
11.11 Connecting a power pack
(accessory)
A power pack (accessory) can be connected
to the flash unit using port
You need a connection cable (special acces-
sory) to connect the power pack.
The power pack extends the operating time
of the flash unit and provides faster flash
recycling times.
D
button
.