Metz mecablitz 64 AF-1 digital Manual De Instrucciones página 182

Strobe flash frequency (f)
Strobe mode allows you to select the flash
frequency (f), which indicates the number of
flashes per second. The number of flashes
can be set from 1 to 100. The maximum
manual partial light output is automatically
adjusted to this number.
If you desire short flashes, you can manually
reduce the partial light output to the lowest
value of 1/256.
+
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
Setting the mode of operation
• Switch on the flash unit with the
TTL
k
0.6- 7.2 m
M-
• Press the sensor button of the displayed
5,6
m
35
Zoom F
m
EV
O
MODE
• Press the
GN
• Press the
STROBO
REMOTE MASTER
p
q
182
button.
The start screen appears.
Thereafter, the flash unit always switches
on with the mode of operation that was
used last.
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
sensor buttons on the
STROBO
touch display and select
STROBO
sensor button on the
touch display.
STROBO
M-
2,5m
m
35
Zoom
m
5
N f(Hz)
P
1/8
STROBO
M-
2,5m
m
35
Zoom
m
5
N f(Hz)
P
1/16
N
3
4
5
p
q
.
• Set a suitable mode of operation on the
M
camera, e.g. .
• Tap the shutter release to transfer data
between the flash unit and the camera.
5
Set number of flashes (N)
• Press the sensor button for the number of
N
flashes on the touch display.
10
• Press the sensor buttons on the
touch display and select the desired num-
ber of flashes.
O
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired number of flashes
4
(in the example .
The setting will take effect immediately.