Technical Data - YATO YT-85080 Manual De Instrucciones

SPECIFICATION OF THE PRODUCT
Chain saw is designed only for wood cutting. Due to the electric drive of the saw, it is possible to cut under the roof or near
buildings. Thanks to the rechargeable power supply the chain saw allows you to work in areas, which are not accessible for to
mains-powered products. The chain saw can also be used for trees cutting, however, because of the threat, it is required, that
trees cutting is performed by an experienced user. Correct, Correct, reliable, and safe operation of the device is dependent on its
proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damages or injuries caused by the tool misuse, resulting from failure to comply with its designation, no compliance
with safety regulations and recommendations included in this manual, the supplier does not accept any liability. The tool misuse
causes also the loss of user's rights to the guarantee and warranty.
PRODUCT EQUIPMENT
The product is supplied in a complete state, but before its first use requires to be assembled.
Along with the chain saw there are supplied:
- chain guide
- cutting chain
- guide shield
- battery
- charging station

TECHNICAL DATA

Parameter
Catalog number
Rated voltage
Rotational speed
The length of guide bar
Chain scale
Width of the leading link
Chain type
Type of the chain guide
Number of teeth of the chain drive wheel and scale
Electric protection class
Oil tank capacity
Weight
Noise level
- L (pressure)
pA
- L (power)
wA
Vibration (front handle / rear handle)
Type of the battery
Capacity of the battery
Energy of the battery
Charging station
Input voltage
Mains frequency
Rated power
Output voltage
Input current
Time of charging
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
O R I G I N A L
14
GB
Unit
[V]
[min -1 ]
[mm /'']
[mm]
[mm]
[ml]
[kg]
[dB (A)]
[dB (A)]
[m/s 2 ]
[mAh]
[Wh]
[V]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-85080
18 DC
2500
250 / 10
9.525
1.27
91PJ040X / 91P040X, Oregon
100SDEA041, Oregon
6 teeth x 9.525 mm
III
210
2.9
80.8 ± 3.0
93.6 ± 3.68
2,53 ± 1,5 / 3,80 ± 1,5
Li-ION
3000
54
230~
50
42
18 D.C.
1.7
2