Technical Parameters - YATO YT-82152 Instrucciones Originales

PROPERTIES OF THE TOOL
The manual wood sawing machine is an electric ordinary tool, insulation class II, designed for cutting of wood surfaces and wood
derivatives surfaces – such as plywood, chipboard, MDF boards, etc., using circular saws. The sawing machine permits comfort-
able cutting of wood both in the vertical plane of the processed surfaces within an adjusted range of the cutting depth as well as at
a certain angle within the adjusted range between 0
to cut along curves (e.g. in circles), since this might cause an accident or imply damage to the saw and the electric tool. A correct,
reliable and safe operation of the tool depends on its correct use, so:
Read the operating manual thoroughly before work and keep it for future reference.
Attention! Under no circumstances can the tool be operated if the guards of the circular saw and the wedge are not
installed.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and indica-
tions contained in this manual.
ACCESSORIES
The box supplied from the factory contains the following:
- sawing machine
- scaled guide

TECHNICAL PARAMETERS

Parameter
Catalogue number
Mains voltage
Mains frequency
Nominal power
Insulation class
Nominal rotation
Maximum cutting depth (0 O / 45 O )
Circular saw
External diameter
Internal diameter
Maximum thickness
Mass
Level of noise
- acoustic pressure L ± K
pA pA
- acoustic power L ± K
wA wA
Level of vibration a ± K
h
Protection grade
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
O R I G I N A L
GB
and 45 . Cutting may also be carried out along a straight line. It is prohibited
0 0
Unit of measurements
[V]
[Hz]
[W]
[min -1 ]
[mm]
[mm]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82152
220 - 240
50
1500
II
4800
65 / 45
185
20
2,8
4,23
95,1 ± 3,0
106,1 ± 3,0
2,860 ± 1,5
IPX0
Value
YT-82154
220 - 240
50
2800
II
4800
85 / 60
235
25,4
3,0
7,75
99 ± 3,0
110 ± 3,0
1,847 ± 1,5
IPX0
13