Technical Data - YATO YT-09955 Manual De Instrucciones

TOOL CHARACTERISTICS
The pneumatic jigsaw is a tool which uses compressed air to operate. Cutting plastics, wood and other metals is possible using
the appropriate saw blades mounted in the tool holder. The tool is suitable for indoor use and should not be exposed to moisture
or precipitation. Proper, reliable and safe operation of the tool depends on appropriate use, that is why you should
read and keep the entire instruction manual before the fi rst use of the tool.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool, failure to observe the safety
regulations and recommendations of this manual. Use of the tool for purposes other than those for which it was intended shall
cause the loss of the user's rights to the warranty, as well as under inconsistencies with the agreement.
ACCESSORIES
The tool is equipped with a connector to connect to the pneumatic system, a saw blade and a guide limiting the cutting depth.

TECHNICAL DATA

Parameter
Catalogue No.
Weight
Diameter of air connector (PT)
Diameter of air supply hose (internal)
Cutting speed
Saw blade stroke length
Maximum metal cutting thickness
Maximum cutting thickness for plastics and wood
Maximum work pressure
Required air fl ow (at 0.63 MPa)
Sound pressure (EN 15744)
Sound power (EN 15744)
Vibrations (EN ISO 28927-8)
GENERAL SAFETY CONDITIONS
WARNING! When operating a pneumatic tool, it is recommended that you always observe basic safety principles, including those
listed below, in order to reduce the risk of fi re, electric shock and injury.
Please read and keep the entirety of this instruction manual before using the tool.
CAUTION! Read all of the following instructions. Failure to do so may result in electric shock, fi re, or personal injury. The term
"pneumatic tool" used in these instructions refers to all tools operating by means of a compressed air stream at the correct pressure.
PLEASE OBSERVE THE FOLLOWING INSTRUCTIONS
General safety conditions
Due to multiple hazards, read and understand the safety instructions before starting installation, operation, repair, maintenance
and alteration of accessories or when working in the vicinity of a pneumatic tool. Failure to do so may result in serious injury.
Pneumatic tools may only be installed, adjusted and assembled by qualifi ed and trained personnel. Do not modify the pneumatic
tool. Modifi cations can reduce effi ciency and safety and increase the risk for the tool operator. Do not throw away the safety
instructions, they should be handed over to the tool operator. Do not use the pneumatic tool if it is damaged. The tool must be
periodically inspected for the visibility of information required by the ISO 11148 standard. The employer/user should contact the
manufacturer to replace the nameplate whenever necessary.
Hazards connected with ejected parts
Disconnect the tool from the power supply before replacing the inserted tool or accessory. Damage to the workpiece, accessories
or even to the inserted tool can result in parts being ejected at high speeds. Always use impact-resistant eye protection. The de-
gree of protection must be selected according to the works carried out. Make sure that the workpiece is securely clamped. Make
sure that sparks from metal cutting are directed in such a way that they do not cause any risk. Make sure that the cutting tool is
attached correctly.
O R I G I N A L
10
GB
Measure Unit
[kg]
[" / mm]
[" / mm]
[min ]
-1
[mm]
[mm]
[mm]
[MPa]
[l/min.]
[dB(A)]
[dB(A)]
[m/s 2 ]
I N S T R U C T I O N S
Value
YT-09955
0.67
6.3 / 1/4
10 / 3/8
9000
10
2
6
0.63
170
78 ± 3
89 ± 3
23 ± 1.5