Sauder Via 422624 Instrucciones De Montaje página 16

Step 11
Fasten the EXTENSION RAILS (J) to the ENDS (A and B). Use ten SILVER 5/8" FLAT HEAD SCREWS (23S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the holes shown in the enlarged diagram. Then, slide
å
the inner cartridge of the EXTENSION RAIL in to fi nd the other holes that lines up with the hole in the END.
Turn a SCREW into these holes.
Insert a METAL PIN (1R) into each END (A and B) as shown.
å
These four small
holes must be here.
Open end
Page 16
1R
J
B
These four small
holes must be here.
A
422624
Open end
J
23S
SILVER 5/8" FLAT HEAD SCREW
(10 used in this step)
www.sauder.com/services