Sauder Via 422624 Instrucciones De Montaje página 24

Step 19
This is a two person step. Carefully stand your unit upright.
å
Completely push two COTTER PINS (19M) into the holes in the CYLINDER BRACKETS (71G) as shown in each large diagram.
å
The cable at the top of the CYLINDER will come assembled for optimal performance. With an adjustable wrench, you can
å
adjust the two nuts on both sides of the cylinder bracket. The same length of threads should be on both sides of the nuts
as shown in the upper large diagram. Be sure to tighten the nuts after making adjustments.
Push the end of the cable through the large hole in the LIFT TOP BACK (F2) as shown in the upper large diagram.
å
Pro Tip: Lift with your
legs. And, you know,
your arms.
Page 24
The MODESTY PANEL and LIFT TOP
have been cut for clarity of assembly.
Push the cable end
through this hole.
F2
IMPORTANT: Use the
CORD MANAGEMENT
for excess cable.
422624
71G
19M
The two nuts on
both sides of the
cylinder bracket
can be adjusted. For
optimal performance,
the same length of
threads should be on
both sides of each nut.
71G
19M
www.sauder.com/services