Cleaning The Cover - Ottobock Terra Instrucciones De Uso

• The flat side points downwards, the contoured side points upwards.
• The hook-and-loop strap on the underside of the cover is used to attach the seat cushion in
the wheelchair.
7.2 Removing/Putting On the Cover
Removing the cover
The cover can be removed so the seat cushion can be washed:
1) Unzip the cover along all three sides.
2) Lift up the cover from the seating surface of the cushion (see fig. 6).
3) Carefully remove the foam base from the cover (see fig. 5).
INFORMATION: Cleaning information see Page 18.
Putting on the cover
1) Unzip the cover along all three sides.
2) Insert the seat cushion into the cover with the zip running along the rear and side edges of the
cushion (see fig. 5).
3) Pull the cover over the seat cushion (see fig. 6).
4) Zip up the cover again.
5) Ensure the cover fits well and there are no large folds or wrinkles on the top surface (see
fig. 10).
7.3 Cleaning
NOTICE
Improper cleaning of the wheelchair seat cushion
Risk of damage to seat cushion due to user error
► Do not machine wash the foam components.
► Do not dry the seat cushion and its components in the tumble dryer.
► Gently wipe the surface of the foam components with a soft, damp cloth or sponge; do not
rub. Do not use a brush or similar on the surface.
To prevent mould formation, the foam components must be completely dry before putting
►
them into the cover.
► Do not wash the cover at a temperature higher than specified. The cover can shrink when
washed at higher temperatures. This could impede the seat cushion's ability to redistribute
pressure and damage the fabric.
► Do not use any bleaching agents or fabric softeners for cleaning.
INFORMATION
► In case of advanced wear and tear, replace the components that are available as spare
parts.
► To disinfect the cover, add a standard hygiene detergent during washing.
In case of heavy incontinence, an additional incontinence cover should be used. Please
►
observe the care and cleaning instructions for the incontinence cover.
Clean the product every month.

7.3.1 Cleaning the cover

1) Unzip and remove the cover for separate washing (see Page 18).
2) Close the zipper on the cover before washing.
3) The cover can be washed at +60 °C [+140 °F] using a mild, environmentally friendly deter­
gent.
Recommendation: Wash the cover using the delicate cycle at +40 °C [+104 °F] to prevent
excessive wear and tear.
18