Washer Care; Cleaning Your Washer - Maytag MHN33PDCWW Instrucciones De Instalación

If cycle counter (9 0C) is selected, the following is true:
1 00 Represents the number
of cycles in HUNDREDS
2 00 Represents the number
of cycles in ONES
This is "VIEW ONLY" and cannot be cleared.
Press the LOWER MIDDLE key pad once to advance to next code.
If money counter (1.0C or 1.C0) is selected, the following
is true:
3 00 Number of dollars
in HUNDREDS
4 00 Number of dollars in ONES
5 00 Number of CENTS
END OF SET-UP PROCEDURES
EXIT FROM SET-UP MODE
PD Models:
Reinstall access door.
PR Models:
1. Unplug washer or disconnect power.
2. Open console, reinsert plug into AA1, close console.
3. Plug in washer or reconnect power.
PR MODELS SET UP AS PN WITH PROGRAMMING SWITCH:
Turn key clockwise and remove.
PR MODELS SET UP AS PN WITHOUT PROGRAMMING
SWITCH:
Set-up mode can be exited by using procedures from Service
Access Code (Below).
SERVICE ACCESS CODE
This code can be entered to access service mode without removing
the console. It only functions on washers set up for 0 vend price
without any Special Pricing set-up, and the Coin/Debit Option must
be set to "J._d". If the washer is not in failure mode, the door must
be opened to proceed. Service Access Code contains four steps.
Perform the following steps:
1. Press the upper left key pad.
2. Press the lower right key pad.
3. Press the upper right key pad.
4. Press the lower left key pad.
NOTE: If the Service Access Code procedure is not completed
properly, as noted above, there is a 15 second delay before it
can be attempted again.
There are three options to exit from the Service Mode:
1. From Set-up Code 8, press the lower left (Temperature)
key pad for 4 seconds.
2. Wait 2 minutes without touching any key pads (without
diagnostic modes running).
3. Power down the washer, then reapply power.
14
1 02 = 200
2 25 = 25
TOTAL CYCLES = 225
3 01 = $ 100.00
4 68 = $ 68.00
5 75 = $ .75
TOTAL = $168.75

WASHER CARE

Cleaning Your Washer

Cleaning the Door Seal/Bellow
1. Open the washer door and remove any clothing or items
from the washer.
2. Inspect inner glass door. If debris is present, wipe off debris
using damp cloth.
3. Inspect the colored seal/bellow between the door opening and
the drum for stained areas. Pull back the seal/bellow to inspect
all areas under the seal/bellow and to check for foreign objects.
A. Seal/Bellow
4. If stained areas are found, wipe down these areas of the seal/
bellow, using the procedure that follows:
Mix a dilute solution, using 3/4 cup (177 mL) of liquid
a)
chlorine bleach, and 1 gal. (3.8 L) of warm tap water.
b) Wipe the seal/bellow area with the dilute solution,
using a damp cloth.
Let stand 5 minutes.
c)
Wipe down area thoroughly with a dry cloth and let
d)
the washer interior air dry with door open.
IMPORTANT:
Wear rubber gloves when cleaning for prolonged periods.
■
Refer to the bleach manufacturer's instructions for proper use.
■
A