Ecoflam BLU 500.1 P Manual página 10

420010268000 Blu 500.1 P ÷ 700.1 P Low Nox
EN
ADJUSTMENT OF GAS MINIMUM PRESSURE SWITCH
Unscrew off and remove cover M. - Set regulator N to a value equal to 60% of
gas nominal feed pressure (i.e. for nat. gas nom. pressure = 20 mbar, set regula-
tor to a value of 12 mbar; for L.P.G. nom. pressure of G30/G31- 30/37 mbar,
set regulator to a value of 18 mbar).Screw up cover M
DJUSTMENT OF THE AIR PRESSURE SWITCH
Unscrew screws A and B and remove cover C.- Set the pressure switch to the
minimum by turning regulator D to position 1.
- Start the burner and keep in low flame running, while checking that combu-
stion is correct. Through a small cardboard, progressively obstruct the air intake
until to obtain a CO2 increase of 0,5÷0,8% or else, if a pressure gauge is availa-
ble, connected to pressure port E, until reaching a pressure drop of 1 mbar (10
mm of W.G.). - Slowly increase the adjustment value of the air pressure switch
until to have the burner lockout. Remove the obstruction from the air intake,
screw on the cover C and start the burner by pressing the control box rearm but-
ton.
Note: The pressure measured at pressure port E must be within the limits of the pressure switch working
range. If not, loose the locking nut of screw F and gradually turn the same: clockwise to reduce the pressu-
re; counterclockwise to increase. At the end tighten the locking nut.
With the burner switched off, connect a DC microammeter with a 0÷50 or 0÷100 μA dial. When the burner is running, and is
properly adjusted, the value read must be steady and never be smaller than 1,5/3 μA.
FLAME DETECTION SYSTEM CHECK
DESCRIPTION OF THE CONTROL PANEL OF THE BURNER
6
I
0
LGB21-LGB22 min. 3 μA
LMG21-LMG22 min. 2 μA
1
LANDIS & STAEFA
1 - fuse
1 - fusibile
1
2 - termal lock-out lamp
2
2 - lampada di blocco termico
3 - working lamp
3 - lampada di funzionamento
4 - cover
4 - coperchio
5 - main switch I / O
3
6 - reset key 5 - interruttore I / O
4
6 - pulsante di sblocco
5
10
N
M
I
L
D
C
A
H
G
E
B
F