Water Connection - Kärcher HD 7/15 G Manual Original

Ocultar thumbs Ver también para HD 7/15 G:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 64
Ventilating the oil container
 Before using for the first time, cut off the
tip of the lid of the oil tank on the water
pump.
Follow the instructions given in the sec-
tion "Safety Notes"!
 Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
 Check oil level of the engine.
Do not operate the appliance if the oil
level has fallen below "MIN".
 If required, top up oil carefully.
 Fill the fuel tank with unleaded petrol.
Do not use 2-speed mixture.
E10 fuel may be used.
DANGER
Risk of fire and explosion!
– Never use the appliance in closed
rooms; do not tank up when the engine
is hot or running.
– Do not smoke during fueling.
– Never fill up in the vicinity of open
flames or sparks.
– Do not spill any fuel – use a funnel.
– Wipe up spilled fuel.
– After refuelling, properly close the can
and tank.
 Fill the fuel tank with unleaded petrol.
Do not use 2-speed mixture.
20
Motor
Refuel

Water connection

For connection values refer to technical
specifications.
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4") to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
 Open the water supply.
Note: The supply hose is not included.
Suck in water from vessel
DANGER
Never suck water from a drinking water
container.
Never suck in liquids which contain sol-
vents like lacquer thinner, petrol or oil. The
spray mist of solvents is highly inflamma-
ble, explosive and poisonous.
 Connect suction hose (minimum diame-
ter 3/4") with filter (accessory) to the
water connection point.
 Set dosing value for detergent to "0".
 Remove air from appliance before oper-
ation.
Dearating the appliance
 Unscrew nozzle screws and remove the
nozzle.
 Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
 Press the lever on the trigger gun many
times.
 Switch on the appliance and let it run
until the water exiting from the spray
pipe is bubble-free.
 Switch off the appliance and fit the noz-
zle again.
EN
– 5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hd 8/20 g

Tabla de contenido