Technical Data - Rupes AR11N Instrucciones Original De Uso Y Manutención

TECHNICAL DATA

INSULATION CLASS
ABSORBED POWER
ELECTRONIC OVERLOAD PROTECTION
ELECTRONIC SPEED CONTROL
ROTATION RPM
COLLET DIAMETER mm
MAXIMUM WHEEL DIAMETER mm
WEIGHT Kg
* On request, collect reduction from Ø 6 to Ø 3 mm.
** On request, collect with Ø 3 mm or Ø 6,35 mm.
The values shown are based on a nominal voltage of 230V/50Hz. In the case of voltages and frequencies of different power values may vary.
Refer to the label technical specifications to the nominal values of the tool.
GENERAL WARNINGS
All instructions concerning safety and the prevention of industrial accidents can be
found in file SAFETY INSTRUCTIONS, that forms integral part of this
documentation. This INSTRUCTION MANUAL only contains additional information
that specifically explain how to use the machine.
SPECIFIC USE
This tool is designed to be used as grinder. Refer to all the safety warnings,
instructions, illustrations and specifications supplied with the tool. Failure to follow
all the instructions provided below may result in electric shocks, fires and/or serious
injuries.
Theuse of this tool for smoothing, metal brushing and polishing operations is not
recommended. Its use for applications other than those for which it has been designed
may lead to hazardous situations and cause injuries to people.
Do not use accessories that are not specifically designed for the intended use of
the tool or that have not been recommended by the manufacturer. The fact that an
accessory can be fixed to the tool does not imply that it can be used safely.
8
TYPE
MILLING GRINDERS
AR11N AR52EN
II II
700 W 600 W
NO YES
NO YES
9.000 3.000÷7.000
6* 6*
45 45
1,1 1,1
The rated speed of accessories must be at least equivalent to the maximum speed
of the tool. If operated at a greater speed than the rated one, accessories may break and
cause the ejection of chips.
The external diameter and thickness of accessories must be appropriate to
guarantee the protection and safety of the tool. Accessories with incorrect dimensions
cannot be adequately protected or controlled.
The configuration of the cutting/grinding wheels or any other accessory must
perfectly adapt to the tool spindle. Accessories with holes that cannot be aligned with
the fitting components on the tools will cause unbalance, excessive vibrations and may
be difficult to control.
Do not use an accessory if damaged. Before use, inspect all the accessories, like
the abrasive cutting/grinding wheels, in order to verify that they are not cracked or
splintered. If the tool or accessory has fallen, verify that they are not damaged and,
if necessary, replace it with a new one. After inspecting or installing an accessory,
move to a safe distance with any other person present and operate the tool at
maximum speed without load for one minute. Damaged accessories generally break
during this test period.
8
ENGLISH
RECTIFICATION GRINDERS
AR38N AR38EN
II II
800 W 800 W
NO YES
NO YES
30.000 18.000÷30.000
6** 6**
25 25
1,1 1,1