Technical Data; General Warnings; Specific Use - Rupes GL040 Instrucciones De Uso

TECHNICAL DATA

PROTECTION CLASS
OPERATING VOLTAGE
ABSORBED CURRENT
ABSORBED POWER
ROTATION RPM
DIAMETER OF THE DISC HOLDER mm
WHEEL DIAMETER mm
SPINDLE THREAD
WEIGHT Kg

GENERAL WARNINGS

SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
The safety and accident prevention instructions are reported in the "SA-
FETY INSTRUCTION" booklet which forms an integral part of these docu-
ments; the operating instructions indicate the additional information re-
quired specifically for use of the tool.
Never use the tools without the safety guards.
Any operations carried out on the tool must be effected with the power
supply disconnected.
Before starting the tool, ensure that it is held tightly and not in contact
with the work surface.
The tool must always be used with the protective shield mounted.
The abrasive wheel must be correctly mounted and tightened.
Make sure that the sparks caused during work do not create danger by
hitting people or inflammable substances.
Hazardous dust may form during use regulation safety devices for
personal protection and observe safety norms valid for the processed
work material.
During tool use pieces of the wheel of work material may break off
causing serious injuries to people or things: remember to always use all
8
TYPE GL040 GL040E
II II
230 V-50 Hz 230 V-50 Hz
5,3 A 5,3 A
1100 W 1100 W
4.500 2.000÷4.500
115 115
- -
M 14 M 14
1,9 1,9
personal protection devices (such as gloves, headphones, goggles, etc.)
according to laws in force to prevent or reduce accident probability.
Warning! the appliance continues to work for a few seconds after it has
been switched off!

SPECIFIC USE

Before use make sure that the wheels or cutters operating characteristics
are compatible with those of the machine and that they are not broken or
worn.
Make sure that the wheels or cutters are assembled, handled and stored
with care according to the manufacturer's indications.
Do not use and adapter system for cutters with tangs other than those
specified.
Do not use the wheel cutting edge as grinder.
Make sure the work piece is sufficiently fastened.
In the event of improper use, the user is fully liable for any damages or
accidents.
ENGLISH
GL080 GL080E
II II
230 V-50 Hz 230 V-50 Hz
5,3 A 5,3 A
1100 W 1100 W
9.500 5.000÷9.500
- -
125 125
M 14 M 14
1,9 1,9
8