Symptoms
• Tracks do not play back in the order you have
intended them to play.
• Elapsed playing time is not correct.
• "No Files" appears on the display.
• "Not Support" appears on the display and
track skips.
• "No Music" appears on the display.
• Correct characters are not displayed (e.g.
album name).
• Noise is generated.
• "File Check" keeps flashing on the display.
• "No Files" appears on the display.
• "Not Support" appears on the display and
track skips.
• "Read Failed" appears on the display, then
returns to the previous source.
• "SD Loading Error" appears on the display
while playing tracks from an SD card.
• While playing a track, sound is sometimes
interrupted.
• Correct characters are not displayed (e.g.
album name).
Remedies/Causes
Playback order is determined when the files are recorded.
This sometimes occurs while playing. This is caused by
how the tracks are recorded on the disc.
Insert a disc that contains MP3/WMA tracks.
Skip to the next track encoded in an appropriate format
or to the next non-copy-protected WMA track.
Change the disc that contains MP3/WMA tracks.
This unit can only display letters (capital: A – Z, small:
a – z), numbers, and a limited number of symbols and
special characters (see page 19).
The track played back is not an MP3/WMA track. Skip to
another file. (Do not add the extension code <.mp3> or
<.wma> to non-MP3 or WMA tracks.)
• Readout time varies depending on the device.
• Do not use too many hierarchy and folders.
• Turn off the power then on again.
Play a device that contains tracks encoded in an
appropriate format.
The track is unplayable.
• The device may be malfunctioning, or may not have
been formatted correctly.
The files included in the device are corrupted.
• Do not pull out or attach the USB memory repeatedly
while "File Check" appears on the display.
Detach the control panel and reinsert the SD card. The
control panel goes back to initial position (Angle 1).
MP3/WMA tracks have not been properly copied into the
device.
Copy MP3/WMA tracks again into the device, and try
again.
This unit can only display letters (capital: A – Z, small:
a – z), numbers, and a limited number of symbols and
special characters (see page 19).
Continued on the next page
31