Special Accessories; Maintenance And Care - Kärcher SV 1802 Manual Del Usuario

 Extension (E1): This is an accessory
that can be used for optimal cleaning of
areas that are very difficult to access.
Ideal for cleaning room heaters, door-
posts, windows, rolling shutter, sanitary
units.
Steam suction - hand nozzle (F)
The use of hand-suction nozzle is used for
glass and mirror surfaces, smooth surfaces
in general or for cleaning fabric areas such
as sofas, mattresses, etc.
The hand nozzle can be combined with the
following accessories. As shown in Figure
D, the accessories are attached to the hand
nozzle. The upper sides of the detachable
lips are marked as "Upper Part".
 Small detachable lip (F1): For smaller
surfaces such as muntin windows and
mirrors.
 Large detachable lip (F2): For window
panes and larger surfaces such as wall
tiles.
 Crown brush (F3): For carpets, stair-
cases, car interiors, fabric surfaces in
general (after carrying out a test at a
hidden area).
A terry towel cover (F4) can also be put
on the brush.
Cleaning windows
Use the following procedure to use the ma-
chine properly for cleaning windows:
 To loosen the dirt, apply steam uniform-
ly on the surface to be treated.
 Press the detachable lip against the
surface to be cleaned and move it from
the top to the bottom and keep the vac-
uum cleaning function on.
Caution!
In seasons when the temperatures are par-
ticularly low, pre-heat the window panes by
letting out steam from a distance of approx.
50 cm from the surface to be cleaned.
Downloaded From Vacuum-Manual.com Manuals
All manuals and user guides at all-guides.com
Round brush kit (order No. 2.860-231) 4
round brushes for the detail nozzle.
HEPA Filter (Order No.. 2.860-229)
Always disconnect the mains plug and al-
low the machine to cool down before per-
forming any maintenance work.
Allow the accessory parts to dry completely
before storing them.
 Do not place the brushes onto the bris-
 Use a moist cloth for cleaning the ma-
 Follow the instructions in the section
 Check the washers in the steam plug
Descale the steam boiler
Note: If you always use usual commercial
distilled water it is not necessary to descale
the boiler.
As limescale builds up on the boiler walls,
we recommend to descale the boiler in the
following intervals (RF=reservoir fillings):
Degree of hardness
I
II
III
IV
– 11
EN

Special accessories

Maintenance and care

DANGER
Care
tles during the cooling and drying proc-
ess to avoid a deformation of the
bristles.
chine from the outside. Avoid using any
solutions or cleaning agents as they
can damage the plastic surfacce.
"Storing the Appliance" for cleaning the
water filter container and for cleaning or
replacing the foam filter (21).
Maintenance
(B1) at regular intervals. Replace them
if necessary. Carry out the same
checks for the connecting washers of
the steam suction pipe (C) and the han-
dle (A).
° dH mmol/l RF
soft 0- 7
medium 7-14 1,3-2,5
hard 14-21 2,5-3,8
very hard >21
0-1,3 100
90
75
>3,8 50
21