Preparing The Appliance - Kärcher SV 1802 Manual Del Usuario

Caution
 Make sure that the power cable or ex-
tension cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the power cable from heat, oil,
and sharp edges.
 Always switch off the machine and re-
move the plug while filling the machine
with water.
 Never fill solvents, solvent-containing
liquids or undiluted acids (e.g. deter-
gents, benzene, paint thinner, and ace-
tone) into the water reservoir as these
substances affect the materials used on
the appliance.
 The appliance must provide of a stable
ground.
 Do not place the machine on heat-sen-
sitive surfaces.
 Do not place the machine in the vicinity
of swtich-on stoves, electrical ovens or
other sources of heat.
 Press the switches lightly and avoid us-
ing sharp objects such as pins, pens/
pencils and similar objects.
 Use and store the unit only in accord-
ance with the specifications in the de-
scription and/or figure.
 The steam switch must not be locked
during the operation.
 Please switch off the machine first us-
ing the main switch before disconnect-
ing the machine from the mains.
 To separate the machine from the
mains, pull the plug and not the power
cord.
 Never wind the main cable around the
machine, definitely not till the machine
is still hot.
 Protect the appliance from rain. Do not
store outside.
Downloaded From Vacuum-Manual.com Manuals
All manuals and user guides at all-guides.com
 Open the safety cap (7) of the steam
 Fill 1.2 litre water into the steam boiler.
 Close the safety cap () carefully.
 Lift the handle (18) of the water filter
 Turn the handle as shown in Fig. 4 and
 Fill the water filter container (17) with
 Add a cap full of foam stop to the water
Note: The functioning of the vacuum clean-
er is based on the whirling of the suction air
in the water filter. In the process, sucked-in
materials and deposits of cleaning agents
from floors get collected in the water bath.
This can sometimes lead to the formation of
foam. It is necessary to add the foam stop
liquid to the water filter bath to avoid this sit-
uation. The foam stop liquid is environ-
ment-friednly and fully bio-degradable.
Slight foam formation is normal and does
not hamper the functioning of the machine.
 Insert the water filter inlay (19) back into
 Lift the handle (18) of the water filter
 Bring the handle (18) back to its initial
– 7
EN

Preparing the Appliance

Filling the steam boiler
boiler (Fig. 1).
Note: You can use normal tap water.
As water naturally contains calcium that
can lead to the formation of deposits in
the boiler, we recommend the use of a
mixture consisting of 50% tap water and
50% distilled water.
Filling the water filter container
container (Fig. 2) and remove the water
filter container (17) (Fig. 3).
remove the water filter unit (19).
tap water till the water level marking
MAX H O is covered (Fig. 5).
2
filter container.
the water container (17).
container and insert the water filter con-
tainer (17) back into the machine.
position on the water filter container.
17