Honda CRF150F 2017 Manual Del Propietário página 131

58
Lubrication and Cleaning
Lubricate every 500 km (300 miles) or sooner if chain
appears dry.
The O-rings in this chain can be damaged by
steam cleaning, high pressure washers, and certain
solvents. Clean the side surfaces of the chain with a
dry cloth. Do not brush the rubber O-rings. Brushing
will damage them. Wipe dry drive chain lubricante
only with drive chain lubricant designed specifically
for O-ring chains. If not available, use SAE 80 or 90
gear oil. Commercial chain lubricants may contain
solvents which could damage the rubber O-rings.
Recommended lubricant:
Drive chain lubricant designed specifically for
O-ring chains
Removal, Cleaning and Replacement
Your motorcycle has an endless (reveted master link)
type chain. It should only be removed or replaced by
your Honda dealer.
When the drive chain becomes dirty, it should be
removed and cleaned prior to lubrication.
1. Clean the side surfaces of the chain with a dry
cloth. Do not brush the rubber O-rings. Brushing
will damage them. Use of a solvent may also
damage the O-rings.
2. Inspect the drive chain for possible wear or
damage. Replace any chain that has damaged
rollers, loose fitting links, or otherwise appears
unserviceable.
Replacement chain: D.I.D. 520VD2
Never use petrol or low flash point solvents for
cleaning the drive chain. A fire or explosion could
result.
3. Inspect the sprocket teeth for possible wear or
damage. Replace if necessary.
4. Lubricate the drive chain.
CRF150F