Frost protection
Warning
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
Store the appliance in a heated room dur-
ing winter or empty it. During longer breaks
in operation, it is advisable to pump in anti-
frost agents into the appliance.
Drain water
Screw off water supply hose and high
pressure hose.
Blow through machine with com-
pressed air.
Flush device with anti-freeze agent
Note
Observe handling instructions of the anti-
freeze agent manufacturer.
Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.
Transport
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Push the push handle down and push
the appliance.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Transport by crane
Connect the lifting device in the center
of the strut to load by crane.
Danger
Risk of injury due to machine dropping.
Adhere to the local accident prevention
–
guidelines and safety notes.
Check the appliance for crane loading
–
for damage prior to each transport by
crane.
22
Driving
Check the lifting unit for damage prior to
–
each transport by crane.
Only lift up the appliance by this mech-
–
anism when loading by crane.
Do not use stop chains.
–
Protect the lifting device from inadvert-
–
ent load release.
Remove the spray pipe with hand spray
–
gun as well as loose articles prior to
transporting by crane.
Do not transport any articles on the ap-
–
pliance during the lifting process.
The appliance must only be transported
–
by properly trained crane personnel.
Do stand stand below the load.
–
Ensure that no persons are present in
–
the immediate vicinity of the crane.
Do not leave the appliance on the crane
–
unattended.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Maintenance and care
Danger
Observe the safety notes in the engine op-
erating instructions prior to any care and
maintenance work.
Danger
Risk of injury if the machine is left running
in an unattended state. Remove the spark
plug before doing any work on the appli-
ance.
Risk of burns! Do not touch hot silencers,
cylinders or radiator ribs.
Carry out maintenance tasks to the engine
according to the specifications provided in
the operating instructions of the engine
manufacturer.
EN
– 8
Storage