Step 2: Calibrating Handpieces; Step 3: Setting The Speed - Nouvag MD 30 Instrucciones De Uso

MD 30
7.4.2

Step 2: Calibrating handpieces

To make sure the displayed parameters correspond with the actual, measurable parameters of the
handpiece or contra angle, it is recommended to calibrate each handpiece or contra angle on a regular basis.
It's a procedure as simple as it is important to guarantee safety and precision of each handpiece or contra
angle being used.
After you take care of all prior preparations such as sterilization, maintenance and care of handpieces,
device preparation and the selection of the handpiece of use, the calibration procedure can be performed.
The calibration of handpieces or contra angles guarantees accurate torque. Due to wear as well as varying
lubrication of the handpieces or contra angles, and lack of maintenance and care, the distribution of
torque can vary widely.
1. Hold motor with mounted handpiece or contra angle in your hand at safe distance from your body.
2. Press both "Speed" keys at the same time (Speed ▲ + Speed ▼).
3. Motor and handpiece start running and pass several speed cycles up to maximum speed.
4. After a tone is emitted and a message is displayed the calibration is finished.
7.4.3

Step 3: Setting the speed

The possible speed range depends on the attached handpiece or contra angle. The maximum speed within
this speed range can be restricted to the required value.
Using the pedal, the speed can be varied from the minimum speed up to the maximum speed as set.
Setting the speed:
Press the «Speed» keys "▲" to increase or "▼" to decrease the maximum speed. When key is pressed
constantly the speeds will be shown in fast forward mode.
The following handpieces run only with one specific speed, it cannot be changed. The specific rpm
values of all handpieces are shown in the table of chapter 7.4.1.
● Micro Compass Saw MSS 5000
● Micro Oscillating Saw OMS 5000
● Micro Sagittal Saw MOS 5000
● Mucotome
MD 30 Operating Instructions, Art. No. 31686, V45/12
All manuals and user guides at all-guides.com
EN
13