Bosch GCM 12 GDL Professional Manual Original página 36

Technical Data
Sliding mitre saw
Article number
Rated power input
Rated voltage
Frequency
No-load speed
Starting current limitation
Laser type
Laser class
Weight according to EPTA-Procedure
01:2014
Protection class
Dimensions of suitable saw blades
Saw blade diameter
Base blade thickness
Max. cutting width
Hole diameter
Permitted workpiece dimensions (maximum/minimum): (see "Permissible workpiece dimensions", page 40)
Noise Information
Noise emission values determined according to EN
62841-3-9.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 93 dB(A); sound power level
106 dB(A). Uncertainty K = 3 dB.
Wear hearing protection!
The noise emission value given in these instructions has
been measured in accordance with a standardised measur-
ing procedure and may be used to compare power tools. It
may also be used for a preliminary estimation of noise emis-
sions.
The noise emission value given represents the main applica-
tions of the power tool. However, if the power tool is used
for other applications, with different application tools or is
poorly maintained, the noise emission value may differ. This
may significantly increase noise emissions over the total
working period.
To estimate noise emissions accurately, the times when the
tool is switched off, or when it is running but not actually be-
ing used, should also be taken into account. This may signi-
ficantly reduce noise emissions over the total working
period.
Assembly
Avoid starting the power tool unintentionally. The
u
mains plug must not be connected to the power supply
Bosch Power Tools
GCM 12 GDL
3 601 M23 601
3 601 M23 631
3 601 M23 671
W 2000
V 230–240
Hz 50/60
-1
min 4000
●
nm 650
mW < 1
1
kg 32.1
/ II
mm 305
mm 1.7–2.6
mm 3.2
mm 30
during assembly or when carrying out any kind of
work on the power tool.
Items Included
Check to ensure that all the parts listed below have been
supplied before using the power tool for the first time:
– Sliding mitre saw with mounted saw blade (40)
– Locking knob (11)
– Hex key (17)
– Hex key (18)
– Screw clamp (19)
Note: Check the power tool for possible damage.
Before continuing to use the power tool, carefully check that
all protective devices or slightly damaged parts are working
perfectly and according to specifications. Check that the
moving parts are working perfectly and without jamming;
check whether any parts are damaged. All parts must be fit-
ted correctly and all the conditions necessary to ensure
smooth operation must be met.
If the protective devices or any parts become damaged, you
must have them properly repaired or replaced by an author-
ised service centre.
Extra tools required (not included in the delivery):
Autogoods "130"
English | 35
GCM 12 GDL GCM 12 GDL
3 601 M23 661 3 601 M23 691
3 601 M23 6P1
1500
110
50/60
4000
–
650
< 1
1
32.1
/ II
305
1.7–2.6
3.2
30
See the list of items included at the start of
the operating manual.
1 609 92A 5RR | (02.07.2020)
1800
220–240
50/60
4000
●
650
< 1
1
32.1
/ II
305
1.7–2.6
3.2
30