Safety Devices; General Safety Instructions - HOLZMANN MASCHINEN ED300ECO Instrucciones De Servicio

15.3

Safety devices

The machine is equipped with the following safety devices:
15.4

General safety instructions

To avoid malfunctions, damage and health hazards when working with the machine, the following
points must be observed in addition to the general rules for safe working:
Before start-up, check the machine for completeness and function. Only use the machine if
•
the guards and other non-parting guards required for machining have been fitted, are in
good operating condition and have been properly maintained.
• Choose a level, vibration-free, non-slip surface for the installation location.
Ensure sufficient space around the machine!
•
Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
•
Ensure a clean working environment.
•
• Only use perfect tools that are free of cracks and other defects (e.g. deformations).
• Remove tool keys and other adjustment tools before switching on the machine.
Keep the area around the machine free of obstacles (e.g. dust, chips, cut parts, etc.).
•
Check the strength of the machine connections before each use.
•
Never leave the running machine unattended. Switch off the machine before leaving the
•
working area and secure it against unintentional or unauthorised recommissioning.
The machine may only be operated, serviced or repaired by persons who are familiar with
•
it and who have been informed of the hazards arising from this work.
Ensure that unauthorised persons maintain a safe distance from the machine and keep
•
children away from the machine.
When working on the machine, never wear loose jewellery, loose clothing, ties or long,
•
open hair.
Hide long hair under hair protection.
•
Wear close-fitting protective clothing and suitable protective equipment (eye protection,
•
dust mask, ear protection; gloves only when handling tools).
Metal dust can contain chemical substances that can have a negative effect on health.
•
Work on the machine should only be carried out in well-ventilated rooms. If necessary,
use a suitable extraction system.
If there are connections for dust extraction, make sure that they are properly connected
•
and in working order.
• Always work with care and the necessary caution and never use excessive force.
Do not overload the machine!
•
Shut down the machine and disconnect it from the power supply before carrying out any
•
adjustment, conversion, cleaning, maintenance or repair work. Before starting any work
on the machine, wait until all tools or machine parts have come to a complete standstill
and secure the machine against unintentional restarting.
HOLZMANN MASCHINEN GmbH
A jaw chuck guard (1) with position switch. The
•
machine only switches on when the jaw chuck guard
is closed.
A protective cover on the headstock.
•
A spiral spring as a protective cover on the
•
leadscrew (prevents clothing from being drawn in).
www.holzmann-maschinen.at
SAFETY
39
ED300ECO