Thread Cutting; Cleaning - HOLZMANN MASCHINEN ED300ECO Instrucciones De Servicio

18.9.7 Thread cutting

Example outside thread:
The workpiece diameter must be turned to the diameter of the desired thread.
•
The workpiece requires a chamfer at the beginning of the thread and an undercut at the
•
end of the thread.
• The speed must be as low as possible.
The thread chisel must correspond exactly to the thread form, be absolutely right-angled
•
and clamped exactly to the turning centre.
The engagement lever for thread cutting must remain closed during the entire thread
•
cutting process. Excluded are the thread pitches which can be carried out with the tapping
watch.
The thread is produced in several cutting operations, so that the turning tool must be
•
completely turned out of the thread (with the facing slide) at the end of a cutting
operation.
• The return path is made with the clasp nut closed and the thread turning tool not engaged
by actuating the "Shift lever Direction of rotation".
Switch off the machine and reposition the chisel in small cutting depths with the cross
•
slide.
Before each run, adjust the upper slide by approx. 0.2 to 0.3 mm alternately to the left
•
and right in order to free the thread. The thread chisel therefore only cuts on one thread
flank in each pass. Do not cut free until shortly before reaching the full thread depth.
19

CLEANING

Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the device after each use of chips and dirt particles.
HOLZMANN MASCHINEN GmbH
1. Loosen the two clamping screws at the front and rear of the
upper slide.
2. Turn the upper slide to the desired position.
3. Clamp the upper slide again.
NOTICE
www.holzmann-maschinen.at
Threading or tapping requires good turning skills
and sufficient experience from the operator.
See the following example
CLEANING
55
ED300ECO