Sauder 404961 Manual Del Usuario página 19

Step Step 14
Insert the LONG METAL PIN (DD) into the small hole in
å
the edge of the RIGHT END (A2). Only insert about 1/4 of
the PIN into the hole.
Slide the patented* LONG END MOLDING (S) onto the
å
notched edge of the RIGHT END (A2). Carefully slide the
MOLDING until the end of the MOLDING is even with the
end of the RIGHT END.
NOTE: The MOLDING should overhang the surface with
å
holes. If the MOLDING overhangs the wrong surface,
remove it and slide it on again.
* U.S. Patent No. 5,499,886
å
www.sauder.com/services
DD
Notched edge
A2
404961
Slide the END MOLDING (S)
onto the notched edge.
S
Page 19