Sauder 404961 Manual Del Usuario página 22

Step 17 Step
Lay the BACKS (L and M) over your unit.
å
Make equal margins along all edges of the BACKS. Push on opposite
å
corners of your unit if needed to make it "square".
Fasten the BACKS to your unit using the NAILS (FFF).
å
NOTE: Be sure to tap NAILS into the holes that line up over SHELF (K3).
å
NOTE: Perforated cut-out lines have been provided for access through
å
the BACKS. Carefully cut out the holes needed.
Fasten an ANGLE BRACKET (FF) to the RIGHT END (A2) and
å
LONG END MOLDING (S). Use two BLACK 9/16" LARGE HEAD
SCREWS (BBB). Use the groove in the LONG END MOLDING.
Using your hammer, gently tap six TACK GLIDES (NN) into the edges of
å
the ENDS (A2 and B) and UPRIGHT (E).
(6 used)
NN
FF
Page 22
These holes must line
up over the SHELF (K3).
A2
S
E
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
L
M
B
BLACK 9/16" LARGE HEAD SCREW
(2 used for the ANGLE BRACKET)
404961
FFF
NAIL
(55 used for the BACKS)
BBB
www.sauder.com/services