Stryker Sidne Manual Del Usuario página 16

The following table shows the Sidne™ voice commands for controlling the
StrykeCAM Overhead Camera.
Device
Top Level
Selection
Sidne Overhead
Camera
Sidne™ Feedback Messages
The following shows the Sidne™ feedback messages and their meanings.
Voice Message
Connected
Disconnected
White Balance Complete
Overhead Camera...
Notes on the Operation of the SIDNE-StrykeCAM Overhead
Camera Interface
1. While the camera is executing any of the following commands initiated
by the SIDNE Interface - Zoom In, Zoom Out, Focus In, Focus Out - all
commands on the tablet interface and all commands on the voice
interface except "Stop" will be disabled. The camera will not respond to
new commands at this point. When the user says "Stop", or releases the
button on the tablet, all commands on the voice and tablet interfaces will
be enabled. Alternatively, if the camera reaches the minimum or
maximum values of Zoom or Focus, respectively, the commands get
enabled.
2. The StrykeCAM Overhead Camera takes approximately 3 seconds to
complete the WhiteBalance command. During this period, all
commands on the tablet interface and all commands on the voice
interface. When the camera completes the WhiteBalance action, all
commands on the voice and tablet interfaces will be enabled. Please do
not attempt to issue any other commands to the camera while it is
completing the WhiteBalance action.
12
All manuals and user guides at all-guides.com
Function Selection
White Balance
Zoom Out
Zoom In
Iris Automatic
Manual
Brighter
Darker
Focus Automatic
Manual
In
Out
Playback Condition
StrykeCAM Overhead Camera is turned on and plugged into Sidne
StrykeCAM Overhead Camera is plugged into Sidne and then disconnected or
turned off
The StrykeCAM Overhead Camera has completed a white balance
Added as a prefix to the above messages, when a feedback message is
announced while not in the Overhead Camera Voice Command menu. Also
added as a prefix to the "Connected" and "Disconnected" messages.
Description
Initiate White Balance
Zoom out continuously
Zoom in continuously
Set Iris/shutter to automatically control brightness
Turn off automatic control of brightness
Increment light level
Decrement light level
Set Camera to automatic focus mode
Turn off automatic focus mode
Focus Camera in
Focus Camera out