Operation; Important - Beurer ELLE HDE 30 Instrucciones Para El Uso

6. Operation

Important

Do not jam the mains cable [8] e.g. in a drawer or door.
Straighten the mains cable [8] if it becomes twisted.
Do not pull, twist or kink the mains cable [8]; do not pull or lay it across/on sharp, pointy objects or
hot surfaces.
Warning
Stand on a dry, electrically non-conductive surface.
Ensure that your hands are dry!
Dry your hair beforehand with a towel.
Depending on the switch setting and duration of use, the volume difuser [1], professional nozzle
[9] and hair dryer can become very hot – burn and ire hazard!
Do not touch the volume difuser [1] and the professional nozzle [9].
Let the volume difuser [1] and professional nozzle [9] cool down irst before you remove them.
Place the hair dryer only on a non combustible surface.
Ensure that there are no highly lammable liquids in the vicinity of the unit.
Do not use the unit on artiicial hair – ire hazard!
Ensure that no hair can be directly sucked in.
Note
After switching on the unit for the irst time, a light odour develops for the irst minutes. This is
normal and not hazardous to your health. Let the unit run for three to ive minutes. Then you can use
the unit normally.
If the unit becomes overheated, it switches of automatically for your safety.
Remove the plug from the socket and let the unit cool down.
Before switching the unit on again, check the air outlet [2] and the ilter [3] for blockage (e.g.
sucked-in lint, dust, hair).
Switch on the travel hair dryer via the slide switch [6.1]:
Strong airlow
Gentle airlow
Select the heat level:
High temperature
Medium temperature
Low temperature
Dry and/or style your hair as you wish.
After each use/interruption, always set the hair dryer slide switch [6.1] to of (position 0).
14