EN
5.4.13.2Dismounting an implement
1. If the implement is a cutting deck: Set the lo-
west cutting height.
Remove the belt protection with use of a 17 mm
spanner (9:A).
The cutting deck must never be opera-
ted without the belt protection assemb-
led. Risk of crushing injury.
2. If the implement is a cutting deck with electric
height adjustment: disconnect the cable from
the machine (5:S).
3. Release the belt tension by removing the tensio-
ner from the belt. See fig. 8.
4. On both sides. Unlock the hitch by pulling it
forward and open the mount by pressing the
handles downwards. See fig. 10.
5. Remove the belt from the pulley on the machi-
ne.
6. Lift the hooks on the implement´s mounting
frame away from the mounts
6 AREAS OF USE
The machine may only be used for the following
tasks using the genuine STIGA accessories stated.
Operation
Accessories, STIGA original
Mowing
With mowing decks:
Villa 320: 78 C
Villa 520: 90 C El
Snow clearance
With snow blade.
Grass clipping
With towed collector.
and leaf collection
Grass and leaf
With dump cart.
transport
Sweeping
Using brush unit. The use of a
dust guard is recommended.
The maximum vertical load on the towing hitch
must not exceed 100 N.
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven
on public roads.
72
ENGLISH
.
Original instructions for use
7 STARTING AND OPERATION
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.
7.1 FILLING WITH PETROL (11:B)
Always use lead-free petrol. You must never use 2-
stroke petrol mixed with oil.
The tank holds 4,2 litres. The level be read on the
fuel meter on the tank (5:M).
NOTE! Ordinary lead-free petrol is a perishable
and must not be stored for more than 30 days.
Environmental petrol can be used, i.e. alkylate pet-
rol. This type of petrol has a composition that is
less harmful for people and nature.
Petrol is highly inflammable. Always
store fuel in containers that are made
especially for this purpose.
Only fill or top up with petrol outdoors,
and never smoke when filling or top-
ping up. Fill up with fuel before starting
the engine. Never remove the filler cap
or fill with petrol while the engine is
running or still warm.
Never completely fill the petrol tank. Leave an
empty space (= at least the entire filler tube plus 1
- 2 cm at the top of the tank) to allow the petrol to
expand when it warms up without overflowing.
7.2 CHECKING THE ENGINE OIL
LEVEL
On delivery, the crankcase is filled with SAE 10W-
30 oil.
Check the oil level every time before using to
ensure it is correct. The machine should be
standing on level ground.
Open the lid (11:C) that covers the dip-
stick. Wipe clean around the oil dipstick.
Unscrew and pull it up. Wipe off the dip-
stick. Slide it down completely and tighten it.
Then unscrew it and pull it up again. Read off the
oil level.
Top up with oil to the "FULL" mark, if the level
comes below it. See fig. 12.
The oil level must never exceed the "FULL" mark.
This results in the engine overheating. If the oil
level exceeds the "FULL" mark, the oil must be
drained until the correct level is achieved.