LUND Genesis Tri-Fold Instrucciones De Instalación página 4

Installation Steps
Securing Front Clamps - Fold Cover Forward
cover
10
Rotate each clamp down from its storage position.
11
Rotate handles back up and slide clamps to edge of truck
bed as shown. For ease of sliding outward, the latch
handle should be in this position until the clamp engages
the bed flange.
13
NOTE: Actual application may vary slightly from illustrations.
cover
2
cover
1
Adjust clamps to proper height. Make sure that the inner
bedwall structure and clamp lid are aligned as shown by
dashed line. Handle height should be adjusted, such that,
the clamp contacts the bed rail flange while the handle is
in the 4 o'clock (LH) or 8 o'clock (RH) position.
12
Rotate clamps to locking position. Repeat for opposite
side. NOTE: A light to moderate force should be felt when
latching to the truck bed. The latches should NOT be
loose when in the LOCKED POSITION.
14
Page 4 of 6
cover
12
4
• Raise to Tighten (UP)
• Lower to Loosen (Down)
3
cover
cover