LUND Genesis Tri-Fold Instrucciones De Instalación página 5

Installation Steps
Bed Cap
Pinch Weld
Clamp Notch
Outside sheet
metal
15
Securing Rear Clamps - Fold Cover Rearward
16
cover
Unlatching and Securing Latches for
Folding and Stowing Cover
cover
17
(1) Slide latch towards the inside of the truck bed, (2)
Return latch handle to vertical position. Latch handle
should be as far into truck bed as possible before
proceeding to next step.
cover
19
NOTE: Actual application may vary slightly from illustrations.
Repeat Step 11 thru Step 14
Slide
1
2
After clamping Tonneau inspect clamps
to make sure the pinch weld is seated
properly in the notch on the clamp. Trim
the bed cap at the clamp location if it
extends down past the metal.
If traveling with the Tonneau in the folded
position it is recommended to use a
safety pin or lock in the front clamps.
1/4" Safety Pin Hole
Rotate latch handle up to disengage truck side rail.
18
Rotate clamp up from its install position into its stor-
age position as shown left. Make sure that latch handle
matches illustration on bow caution label.
20
Page 5 of 6
cover
cover
cover