Maintenance And Care - Kärcher NT 14/1 Classic Manual Del Usuario

Tabla de contenido

Publicidad

After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
Storing the Appliance
Illustration
 Store the suction pipes and the floor
nozzle as shown in the illustration.
 Place the appliance in a dry room and
secure it from unauthorized use.
Transport
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Hold the appliance at the handle and at
the suction pipe to transport it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Exchanging the flat pleated filter
 Open filter door.
 Replace the flat pleated filter.
 Close the filter door, it must lock into
place.
Replace the exhaust filter.
 Release and remove the suction head.
 Turn the suction basket by 180° and
keep it aside.
 Unlock the filter frame and remove it.
14
Storage
 Remove the exhaust filter from the filter
frame.
 Insert new exhaust filter into filter frame
as per appliance overview.
 Insert the filter frame so that the X is
pointing toward the outside.
 Let the filter frame lock in.
 Insert and lock the suction head.
Cleaning the electrodes
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.
Troubleshooting
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Suction turbine does not run
 Check cables, plugs, fuse, socket and
electrodes.
 Turn on the appliance.
Suction turbine turns off
 Empty the container.
Suction turbine does not start
again after the container has been
 Turn off the appliance and wait for 5 sec-
onds, turn it on again after 5 seconds.
 Clean the electrodes as well as the space
between the electrodes with a brush.
Suction capacity decreases
 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Replace the paper or fleece filter bag.
 Ensure the filter cover properly locks
into place.
 Replace the flat pleated filter.
 Clean the exhaust filters under running
water and let them dry off.
EN
3
-
emptied

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1.510-128

Tabla de contenido