Intended Use; Technical Data; Functional Description; Commissioning - Festool OF 1010 REQ-F Instrucciones De Uso Original

The risk from these expo­
sures varies, depending on
how often you do this type of
work. To reduce your expo­
sure to these chemicals:
work in a well ventilated
area, and work with approved safety equipment,
such as dust masks that are specially designed
to filter out microscopic particles. Wash hands
after handling.
WARNING
TO REDUCE THE RISK OF INJURY, USER
MUST READ INSTRUCTION MANUAL.
4

Intended use

The router is designed for routing wood, plas­
tics and wood-based materials.
If the cutters are used for the intended purpose
outlined in the Festool Sales, they may also be
used to machine aluminium and plasterboard.
This power tool may only be used by experts or
instructed persons.
The user is liable for improper or non-in­
tended use.
5

Technical data

Router
Power input
Rated current
Speed
Max. speed (no-load)
Quick depth adjustment
Fine depth adjustment
Drive shaft connecting
thread
Cutter diameter
Weight as per EPTA
procedure 01:2014:
6

Functional description

[1-1]
Router table
[1-2] Stepped stop
[1-3]
Depth stop
[1-4] Locking for trammel unit
[1-5]
Nut
OF 1010 REQ-F
1010 W
8.4 A
9500 - 23000 min -1
26000 min -1
2-1/8" (55 mm)
5/16" (8 mm)
M16 x 1.5
max. 1-3/8" (35 mm)
6.8 lbs. (3.1 kg)
[1-6]
Spindle stop
[1-7] Handle/Height adjustment
[1-8] Clamp lever
[1-9]
Fine adjuster
[1-10] Depth stop indicator
[1-11] Speed adjusting wheel
[1-12] Locking button
[1-13] Handle
[1-14] On/off switch
[1-15] Extractor connector
[1-16] Grooves for guide bars/parallel side
fence
The pictures for the functional description are
on a fold-out page at the beginning of the in­
struction manual. While reading the manual
you can fold out the page for comparison and
quick reference.
Accessories shown or described are not always
included in the scope of delivery.
7

Commissioning

WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
► Connect and disconnect the mains power
cable - [2].
English
9