Assembly - ProMinent DULCOTEST CLO 1 Manual Del Operacion

Assembly

4 Assembly
n
Users' qualifications: trained qualified
Ä Chapter 1.2 "Users' qual‐
personnel, see
ifications " on page 10
18
Electrolyte filling
NOTICE!
Perform the following work over a sink
After this, carefully re-close the electrolyte
bottle. Unclosed electrolyte bottles may
severely limit the storage period of the elec‐
trolytes.
1. Remove the red end cap and cut off the
top end of the spout with a knife.
2. Screw the sensor cap (1) and the sensor
cap protector (2) off from the sensor shaft
2
Fig. 2: Sensor cap (1) with sensor cap protector
(2)
3. With the sensor cap protector plugged
on, place the sensor cap onto a working
surface
The sensor cap protector seals the
ð
bottom of the sensor cap.
1
A0107