Usage; Using Your Induction Hob - Teka IBC 63 BF100 Manual De Instrucciones

Using your induction hob

To start cooking
1� Touch the ON/OFF control�
After power on, the buzzer beeps once, all displays show " –
" or " – – ", indicating that the induction hob has entered the
state of standby mode�
2� Place a suitable pan on the cooking zone that you wish to
use�
• Make sure the bottom of the pan and the surface of the
cooking zone are clean and dry�
3� Select one heating zone and set a power level by touching the slider, or the "+" or
"-" control, or just touch any point of the "—"�
a� If you don't set the power within 1 minute, the induction hob will automatically
switch off� You will need to start again at step 1�
b� You can modify the heat setting at any time during cooking�
c� If slide along the "—", power will vary from level 1 to level 9�
If the display flashes
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone�
No heating takes place unless there is a suitable pan on the cooking zone�
The display will automatically turn off after 1 minutes if no suitable pan is placed on
it�
When you have finished cooking
1� Turn the cooking zone off by sliding along the "—" to the left point, and then hold
for 1 second�

Usage

or
alternately with the heat setting
EN-14
or