Tools Needed - Power Stroke PS142200 Manual Del Operador

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.

TOOLS NEEDED

See Figure 4.
The following tool (not included or drawn to scale) is needed
for assembly:
 Phillips Screwdriver
INSTALLING THE WHEELS
See Figure 5.
 Locate the axles, hitch pins, and wheels.
 Slide the axle through the hole in the center of the wheel.
 Lift the machine and slide the axle into the wheel mount-
ing hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
INSTALLING THE HANDLE AND NOZZLE
STORAGE BRACKET
See Figures 6 - 7.
Installing the handle:
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
Push and hold the push-pin button on the side of the handle
as you slide the handle onto the frame.
NOTE: Before use, pull the handle up until the lock button
snaps through the locking slots to secure the handle in place.
ASSEMBLY
Installing the nozzle storage bracket:
 Align the nozzle storage bracket with the holes in the
handle, as shown.
 Install screws and tighten securely.
INSTALLING THE TRIGGER HANDLE
HOLDER
See Figure 8.
 Align the trigger handle holder with the hole in the handle,
as shown.
 Install the screw and tighten securely.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 9.
 Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
 Turn the connector until it stops to secure the spray wand
in place.
CONNECTING THE HIGH PRESSURE HOSE
TO THE TRIGGER HANDLE
See Figure 10.
 Screw the collar on the high pressure hose onto the trigger
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PUMP
See Figure 11.
 Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using the High Pressure Hose in Operation
for more information about using the high pressure hose.
 Align the collar on the hose to the threaded outlet on the
pump.
 Install the high pressure hose collar onto the threaded
outlet.
 Turn the collar clockwise to tighten the hose securely to
the pump.
NOTE: Be careful to avoid cross-threading, which can
cause the hose to leak during use.
 Pull on the hose to be certain it is properly secured.
9 — English