Power Stroke PS14133B Guía De Referencia Rápida

WARNING:
This quick reference guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using this product. All page references refer to
the operator's manual.
FIRST TIME ASSEMBLY
Connect the high pressure hose to the trigger
1 5
Install the wheels (see page 9).
handle (see page 10).
2 Install the handle (see page 9).
Connect the high pressure hose to the pump
6
(see page 10).
Install the trigger handle storage bracket
3
(see page 9).
Connect your garden hose to the pressure washer
7
(see page 9).
Connect the spray wand to the trigger handle
4
(see page 9).
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until a
steady stream of water appears.
PS14133B QUICK REFERENCE GUIDE
STARTING THE UNIT
Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
1
ready for operation (see page 11).
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 2 and 7).
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length
100 ft.
NOTE: A.W.G. = American Wire Gauge
2 Put the on/off switch in the ON position to start the motor (see page 11).
ON/OFF SWITCH
(ON POSITION)
3
When finished, put the on/off switch in the OFF position to stop the motor (see page 11).
ON/OFF SWITCH
(OFF POSITION)
Pour pressure washer
1
detergent in soap tank
(see page 13).
Use of soap nozzle will activate soap injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
Wire Size (A.W.G.) • Will void your warranty
• Will damage plants/shrubs
25 ft. 14
50 ft. 12
Not Allowed
Use the chart below to determine the correct nozzle for your job.
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
Always add Pump Protector to the unit after each use and before storing. This will significantly
1
improve pump life. (See page 14)
Pump Protector is available from your local retailer. For further assistance, call customer service at
1-877-617-3501.
To add, follow the instructions provided by the pump protector manufacturer.
Go to www.powerstroketools.com and register
your new tool online. For questions about operating
or maintaining your product, please call 1-877-617-3501.
USING DETERGENT
Install blue soap nozzle Squeeze trigger and wait
2 3
(see page 12). approx. 5 seconds for
detergent (see page 13).
NOZZLE SELECTION GUIDE
HIGH PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
15º
Turbo Nozzle
 



 Recommended Nozzle
Use With Caution for Certain Applications

BEFORE STORING THE UNIT
Make the most of your purchase!
5 S
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Blue
Soap Nozzle




PUMP
PROTECTOR
991000817
12-2-15 (REV:01)