Using The Load Leg - Cybex Platinum ATON Q Manual Del Propietário

The Load Leg is an effective safety feature of the Aton Q and
using it is STRONGLY RECOMMENDED.
(e.g. in a center position with a hump in the floor), the Base may
be installed with the Load Leg folded up underneath the Base. If
ALL installation requirements for the Load Leg cannot be met,
you MUST choose another seating position, or install the Infant
Carrier without the Base.
When possible, INSTALL the Aton Q Base in a seating
position that will allow the Load Leg to be extended
into a locked position with firm contact with the
vehicle floor.
NEVER INSTALL the Aton Q Base in a seating position
where the Load Leg, even in its shortest position,
causes the Base to be pushed up above the vehicle
seat. If necessary, the Base may be installed with the
Load Leg folded up underneath the Base.
NEVER EXTEND the Load Leg Foot beyond the FIRST
hole that will lock it firmly against the vehicle floor.
TO EXTEND
1. Install the Base making sure Recline Angle is
correct for your child. See page 24.
2. Squeeze the Adjustment Handle on the Load Leg and
extend the Foot until it rests on the vehicle floor.
3. Secure the Foot into place using the first hole that will lock it firmly
against the vehicle floor without lifting the Base up off of the seat.
It may be necessary to lift up slightly on the Base to allow the Foot to
lock into the hole.
TO RETRACT
Squeeze Handle and push up on the foot to retract.
23
All manuals and user guides at all-guides.com

USING THE LOAD LEG

However, if necessary
1
2
There should NEVER be
any space between the
Load Leg Foot and the
vehicle floor.
The Base should NEVER
be pushed up above the
vehicle seat.
Use the FIRST
hole that will lock
the Load Leg Foot
firmly against
vehicle floor