Preparation; Charge The Host; Battery - Thinkcar THINKTOOL Manual Del Usuario

www.mythinkcar.com
THINKPRINTER
Print Density: 576dots/line
Print Width: 3.1inches (80mm)
Print Speed: 2.3inches/s (60mm/s)
Working Environment: 14 ~122
Storage Environment: -4 ~140
THINKPRINTER Thermal Paper
Length: 19.6ft~22.9ft (6m~7m)/roll
Working Environment: 14 ~122
Storage Environment: -4 ~140

4 Preparation

4.1 Charge the host

Follow the steps below to charge the host:
1. Connect one end of the power cord to the USB socket of the power adapter.
2. Connect the other end to the charging jack on the bottom of the host.
3. Plug the charger power plug into a power outlet to start charging.
When the battery status icon displays
, the charging process has been completed and you shall disconnect the host.

4.2 Battery

It is normal that the host won't turn on when charging because the battery has not been
used for a long time or it is exhausted. Please turn on the host again after charging the
battery for a while.
Please charge the host through the charger in the package. The company assumes
no responsibility for damages and losses caused by charging with chargers other than
The battery can be recharged repeatedly. However, as the battery is wearable, the
standby time of the device will be shortened after long-time use. Please avoid frequent
repeated charging so as to extend battery life.
The battery charging time varies with temperature and battery status.
When the battery power is low, the system will pop up a prompt reminding you to
connect the charger. When the battery power is too low, the device will turn off.
(-10 ~50 )
(-20 ~60 )
(-10 ~50 )
(-20 ~60 )
, the host has been charged. When it displays
15