Cameo OTOS H5 Manual De Usuario página 19

Slave
Receive Set
Mode reception
mode
Wireless Disconnect all connections and place in pairing standby mode
Reset
STANDALONE MODE (Scenes)
Similar to when using a DMX control unit, the standalone operating mode Scenes makes it
possible to set pan, tilt, zoom, pan/tilt macros etc. directly on the device with values from 000 to
255. A total of 8 individual scenes (Scene 1–8) can be created, edited, saved and recalled.
Starting from the main display, press MENU to enter the main menu. Use UP and DOWN to select
the Control menu and press ENTER. Now select the menu item Stand Alone and confirm again.
Information on the sub-menu items in the Scenes menu and the corresponding setting options
can be found in the table below.
Stand Alone (Scenes)
Run Scene Start Scene
Record Scene Record a scene from an external controller
Edit Scene Edit scene (see table Edit Scene)
Master/Alone Output scene as control signal to one or more slave units
Do not output scene as control signal (Alone)
Copy to Slave Transfer scenes 1 to 8 via DMX cable to one or more slave
units (same model, same software version). Carry out
procedure with Yes. The scene memory of the slave units is
completely overwritten. Cancel the operation with No.
Edit Scene
Pan 000 – 255 0% -> 100%
Pan Fine: 000 – 255 0% -> 100%
Tilt 000 – 255 0% -> 100%
Tilt Fine 000 – 255 0% -> 100%
Signal reception exclusively via DMX IN
Signal reception via DMX IN, with signal interruption via
W-DMX
Signal reception via W-DMX, with signal interruption via
DMX IN
Signal reception exclusively via W-DMX
XLR Only
XLR First
Wireless First
Wireless Only
Scene 1–8
Scene 1–8
Scene 1–8
Master
Alone
No
Yes
19