Cameo OTOS H5 Manual De Usuario página 33

6. The gobo can now be removed from the bracket and replaced with another one.
7. Then place the gobo bracket back into the gobo wheel, ensuring that the gobo bracket is
correctly seated in the corresponding recess. You can check that the gobo is seated correctly
by turning the gobo wheel. The gobo must rotate without catching.
8. Reinstall the module in the spotlight head, secure it using the two Phillips screws previously
loosened and reattach the cover safety cable.
9. Remove the old seal from the groove in the installation bay surround.
10. Thoroughly clean the groove and the contact surface of the cover. Make sure that the contact
surfaces of the seal are free from foreign objects and dirt.
11. Remove the new seal from the packaging and remove any residues of the mould release
agent.
12. Now place the seal positively into the groove. Ensure that the seal is not twisted.
13. Place the cover flat on the seal in the installation bay surround.
14. First tighten the middle and then the outer screws of the cover crosswise with gentle force.
15. Then tighten the middle screws and then the outer screws crosswise to 6 (± 0.5) kgf-cm.
16. After mounting the cover, perform a leak test. This requires the removal of the rear head
cover. To do this, loosen the 4 Allen screws on the rear head cover, remove the cover from
the spotlight, loosen the safety cable of the cover and place it to one side.
17. After the leak test, fasten the safety cable of the rear head cover in the appropriate position,
place the head cover on the spotlight head and screw it in place using the previously loosened
screws (10 (± 0.5) kgf-cm).
Never operate the spotlight without the fan unit and head cover!
6
33