Cameo OTOS H5 Manual De Usuario página 24

Service
Default values
Reset
Test
Reset Runtime
Password
QUICKLIGHT
Set up a scene quickly and easily using the basic Moving Head functions without an external
controller. Starting from the main display, press MENU to enter the main menu. Use UP and
DOWN to select Quicklight and press ENTER.
If the Quicklight mode is activated, the display does not automatically change to the main display;
when leaving the Quicklight menu, Quicklight mode is automatically terminated. The settings in
the Quicklight menu are retained until the next restart of the spotlight; as a result, Quicklight can
be accessed repeatedly with the same settings as long as the spotlight remains switched on.
After restart, the values in the Quicklight settings are reset (PAN = 000, TILT = 128, DIMMER =
255, ZOOM = 000, FOCUS = 000).
24
Factory Resets to factory setting
User A Resets to User A values (save user values: Settings -> Set
def. values)
User B Resets to User B values (save user values: Settings -> Set
def. values)
User C Resets to User C values (save user values: Settings -> Set
def. values)
All Resets all motors
Pan / Tilt Resets pan / tilt motors
Head Resets motors in the device head
Test Sequence Pre-programmed sequence to test all components
Stress Test Pre-programmed sequence to test all components under
maximum load
Run Motor Activate all motors individually with values of 000 to 255
Service No Do not reset service operation time
Yes Reset service operation time
Lamp No Do not reset lamp operation time
Yes Reset lamp operation time
For service purposes only