Cameo OTOS H5 Manual De Usuario página 32

In order to maintain the seal of the OTOS H5 moving head according to protection
class IP65, a new seal must be inserted at the corresponding location after replacing
a gobo. Carefully follow each step in the instructions below.
1. Switch off the lamp (Settings -> Lamp -> State -> Off), then activate a DMX mode and
disconnect the spotlight from the DMX control. Before opening the spotlight, perform a normal
system start and only remove it from the power supply when the process is complete. When
the system is started, the zoom tube is moved all the way forward in the direction of the light-
emitting lens, among other things, to enable removal of the colour wheel and gobo wheel
module. After fully disconnecting the spotlight from the power supply (pull out the power
plug), bring the spotlight head to the maximum horizontal position so that the zoom tube
remains in the front position. Now lock the spotlight head.
2. Loosen the 8 Allen screws of the cover for the installation bay of the colour wheel and gobo
wheel module (see markings), remove the cover from the spotlight head, loosen the safety
cable of the cover and place it to one side.
3. Loosen the 2 Phillips screws that hold the module in the guide rail (see markings) and pull the
module out of the spotlight head; cables or plugs do not have to be loosened.
2
4. Place the module on a clean, level surface with the colour and gobo wheels facing upwards.
Manually rotate the "Open" section of the gobo wheel with the fixed gobos forward and then
the gobo wheel with the interchangeable gobos until the desired gobo appears in the "Open"
section of the gobo wheel with the fixed gobos.
5. Lift the gobo bracket slightly up on the gear and then pull it out of the gobo wheel.
4
32
3
5