Setting A Pre Roll Point; Rehearsing Punching In And Out; Using Automatic Punching In And Out - Tascam 16 Manual Del Usuario

6 - Recorder functions

Setting a pre roll point

When using automatic punch in, the amount of playback time
before the punch in point can be set (pre roll point).
1. Select A.PUNCH PRE ROLL on the MENU screen to open
the A.PUNCH PRE ROLL screen. (See "Menu operation
procedures" on page 28)
2.
Set the pre-roll point.
Option Meaning
Do not locate to a point before the
punch in point. Manually moving to
OFF
somewhere before the punch in point
beforehand will be necessary.
Locate to a pre roll point the set time
1sec. – 10sec.
before the punch in point and start
(default: 2sec.)
playback.
3. Press the F1
button to return to the MENU Screen.

Rehearsing punching in and out

You can rehearse before punch in/out recording. In rehearsal,
recording will not occur, but monitoring will be the same as if
recording.
1. Press the MENU button when the recorder is stopped to
open the Home Screen.
Confirm that the
2. Press the REC buttons for the tracks you want to record
using automatic punch in/out.
NOTE
Punch in recording is not possible when the REC button is on
for eight or more channels.
3. Press the 7/9 button.
Auto punch in/out rehearsal starts.
o The transport starts playback from the pre-roll point.
Both track playback and input source signals can be
monitored. (See "Setting a pre roll point" on page 42)
o When the punch in point is reached, only the input
source signal will be monitored. The 0 button will
blink showing that it is rehearsal mode.
o When the punch out point is reached, both track
playback and input source signals will be monitored.
The 0 button will become unlit.
o Playback will automatically stop two seconds after the
punch out point. The 7/9 button will blink.
Rehearsal can be repeated.
42
TASCAM Model 16
icon appears on the Home Screen.

Using automatic punching in and out

Follow these procedures to punch in and out automatically and
record.
1. Confirm that the
2. Press the REC buttons for the tracks you want to record
using automatic punch in/out.
NOTE
Punch in recording is not possible when the REC button is on
for eight or more channels.
3.
Press the 0 button.
o The transport starts playback from the pre-roll point.
Both track playback and input source signals can be
monitored. (See "Setting a pre roll point" on page 42)
o When the punch in point is reached, only the input
source signal will be monitored. The 0 button will
light.
o When the punch out point is reached, both track
playback and input source signals will be monitored.
The 0 button will become unlit.
o Playback will automatically stop two seconds after the
punch out point. The 7/9 button will blink.
icon appears on the Home Screen.