Stihl SR 430 Manual De Instrucciones página 23

A B
– Standard metering knob (A) with
positions 1 to 5
– Fine metering knob (B) with
positions 1.0 to 2.3
1)
– ULV metering knob (C) with
positions 0.5 to 0.8
Changing the metering knob
N Pull the existing metering knob up
and out of its seat.
N
Push the new metering knob into its
seat as far as stop.
1)
Included in the scope of supply or
available as a special accessory -
depending on market
SR 430, SR 450
Fitting the strainer
The strainer supplied must always be
fitted when the ULV metering knob is
C
used.
SR 430
SR 450
N Push the strainer into its seat until it
snaps into position.
Removing
N Pry the strainer out of its seat – as
shown.
2)
Included with ULV metering knob
2)
Adjusting the discharge rate
N
The numbers on the metering knob must
be lined up with the lug (4) under the
knob.
Position "E" is used for emptying the
container. Do not use this position for
spraying – see "After Finishing Work".
Machines with pressure pump
(special accessory)
On machines with a pressure pump, use
only the supplied "fine" metering knob
with settings 1.0 to 2.3 or the ULV
metering knob with settings 0.5 to 0.8.
Discharge rate without pressure
pump
Spray tube 0° to -30° to the horizontal
2
4
3
Turn the metering knob (2) on the
nozzle (3) to obtain the required
discharge rate – see tables.
English
21