Using Steam And Suction Simultaneously; Using Steam And Liquid Suction Simultaneously; Fig - Lavor GV EGON VAC Manual Del Usuario

It is possible to change the power level with suction both on
and off. Every time the quick connector (27) is removed, at the
next insertion the suction power level restarts from 1st level.

7.3 Using steam and suction simultaneously

Please refer to the chapter "Starting up the boiler" before use.
It is possible to combine the steam cleaning and suction
functions described above to perform the washing and suction
cycles at the same time. When work is finished, release the
steam lever (29) a few moments prior to switching off the
suction motor button (30). This will allow the suction ducts to
recover the humidity.
Note: Whilst you are working, it is normal to occasionally hear
the pump as it pumps in the water. Be careful not to confuse
this noise with the audible warning signal (beep) made when
the boiler water tank is empty.

7.4 Using steam and liquid suction simultaneously

• Fully press the two buttons (U) to the sides of the handgrip
(T) (Fig. 11).
• Lift the handgrip (T).
• Lift the handle (N) and remove the tank (M) (Fig. 12).
• Remove the HEPA filter (X) (Fig. 13).
• Overturn the handle (N) of the tank and slide out in
backward lower direction the filter assembly with float (O)
(Fig. 14).
• Disassemble the solids filter (R) (Fig. 15).
EN
T
U
N
M
X
O
P
S
R
N
S

Fig. 11

Fig. 12
Fig. 13
Fig. 14
M
Fig. 15
R
37