Dust Vacuum Function With; Water Filtering - Lavor GV EGON VAC Manual Del Usuario

7.5 Dust vacuum function with water filtering
IMPORTANT: the microfibre filter (P) must not be used with
water filtering function.
IMPORTANT: the HEPA filter (X) must not be used with water
filtering function.
Water filtering allows to "capture" dirt while keeping the
output air clean, resulting in even more effective cleaning.
Proceed as described in section "Preparing the vacuum cleaner"
by replacing the microfibre filter (P) with the sponge filter (Q)
(Fig. 17).
Add 1 litre of tap water inside the tank (M), until reaching the
MAX level mark on the tank (Fig. 23).
CAUTION! Do not pour detergents or flammable substances
in the tank.
CAUTION! Never perform suction if the sponge filter (Q) is
not installed.
CAUTION!
• Do not vacuum explosive, toxic and inflammable substances (e.g. chimney ashes and soot) or
substances that may be dangerous to your health.
• Do not use the appliance to suck liquids from containers, sinks, baths, etc.
• Do not suck foam
• If foam forms inside the tank, turn off the appliance immediately and empty the tank (M).
• During liquid suction on surfaces, do not exceed the MAX level inside the tank (M)
• The appliance is equipped with safety float (O1) (Fig. 17), which triggers if the maximum
permitted level of liquid inside the tank is exceeded (Fig. 23). In this case there is no appliance
suction and simultaneously the motor revolutions increase. Turn off the appliance and empty
the tank (M), see section "Emptying the tank (M)".
EN
Fig. 21
M
Fig. 22
Fig. 23
M
– MAX
39