Fig. 16 - Lavor GV EGON VAC Manual Del Usuario

• Disassemble the lower filter cover (S) (Fig. 16).
• Replace the microfibre filter (P) and insert the sponge filter
(Q) in the proper seat (Fig. 17).
Note: Sponge filter (Q): to be used for liquid suction.
• Fully insert the lower filter cover (S) (Fig. 18).
• Fully insert the solids filter (R) (Fig. 19)
Note: Solids filter (R): performs a first filtering of debris and
dimensionally significant bodies.
• Check proper fitting of the assembly, with filter, lower filter
cover (S) and solids filter (R) fully inserted.
• Reposition the filter unit (O) with float (O1) in the tank (M).
• With the handgrip (T) lifted, reposition the tank (M) on the
appliance.
• Lower the handgrip (T).
• Close the handgrip (T) by pushing down and check proper
click of buttons (U).
Note: During liquid suction on surfaces, do not exceed the MAX
level inside the tank (M) (Fig. 20).
Note: The appliance is equipped with safety float (O1) (Fig. 17),
which triggers if the maximum permitted level of liquid inside
the tank (M) is exceeded (Fig. 20). In this case there is no
appliance suction and simultaneously the motor revolutions
increase. Turn off the appliance and empty the tank (M).
CAUTION! Do not pour detergents or flammable substances
in the tank.
CAUTION! Never perform suction if the sponge filter (Q) is
not installed.
CAUTION!
• Do not vacuum explosive, toxic and inflammable substances (e.g. chimney ashes and soot) or
substances that may be dangerous to your health.
• Do not use the appliance to suck liquids from containers, sinks, baths, etc.
• Do not suck foam
• If foam forms inside the tank, turn off the appliance immediately and empty the tank (M).
• In case of water filtering, replace it when cloudy.
38

Fig. 16

S
O Fig. 17
O1
P
Q
Fig. 18
Q
S
Fig. 19
Q
Fig. 20
M
– MAX
R
EN