Using The Attachments - Lavor GV EGON VAC Manual Del Usuario

See list of attachments and components.
The attachments can be directly connected to the handgrip
(26) or, depending on your needs, to the extension tubes (2).
• Fitting the attachments: fit completely until the lower
hooking lever (33) is hooked (Fig. 24).
• Disconnecting the attachments: press the lower lever
(33) and pull out the attachment. (Fig. 24).
CAUTION! Make sure it is properly fastened by pulling it
slightly.
CAUTION! Never separate the attachments when steam is
coming out. Risk of burns.
BIG BRUSH (3)
• insert the brush holder hook (4) up to the curve of the neck
of the big brush (3), leave one tooth free as shown in
(Fig. 25),
• screw the two screws.
• fully insert the extension tube (2) until the hooking of the
lower lever (33) (Fig. 26) (Fig. 27).
CAUTION! Make sure it is properly fastened by pulling it
slightly.
40

8 USING THE ATTACHMENTS

PH2
33
2
CLICK! CLICK!
Fig. 24
2
33
Fig. 25
3
4
Fig. 26
3
Fig. 27
30
EN