Diamond ATLANTIS TM69 LED Manual De Usuario página 35

PROGRAMMING SYSTEM TM69 LED
1st cycle 2nd cycle
(Step 2) (Step 3)
3'00'' 32'00''
Step 2; First cycle: backwash. Indicates the
backwash duration in minutes and seconds.
2-10
Press the menu / confirmation button to change and
adjust the times according to the table indicated by
the up / down buttons. Once the desired values has
been set, press the menu / confirmation button to
confirm:
Step 3; Second cycle: brine aspiration. Indicates
the brine suction time.
3-60
Press the menu / confirmation button to change and
adjust the times according to the table indicated by
the up / down buttons. Once the desired values has
been set, press the menu / confirmation button to
confirm:
Step 4; Third cycle: water filling. Indicates the
time in which water is filled to the salt tank so that
in the next regeneration, the water softener has
the required brine to perform the second cycle
of the next regeneration.
4-05
Press the menu / confirmation button to change and
adjust the times according to the table indicated by
the up / down buttons. Once the desired values has
been set, press the menu / confirmation button to
confirm:
3rd cycle 4th cycle
(Step 4) (Step 5)
5' 00'' 4' 00''
Step 5; Fourth cycle: quick wash. Indicates the
washing duration to eliminate possible salt residues
in the resin tank.
Press the menu / confirmation button to change and
adjust the times according to the table indicated by
the up / down buttons. Once the desired values has
been set, press the menu / confirmation button to
confirm:
Days between regenerations: In the next step, H-30
will display (it is factory programmed) and it means
that the water softener will be regenerated every 30
days regardless of the water that may have passed
through the device.
We recommend modifying the parameter by
pressing the menu / confirmation button, and using
the up / down buttons, select H-00.
Confirm once again using the menu / confirmation
button.
In this case, the regeneration will be carried out
according to the liters of selected resin, regardless of
the elapsed time.
If instead of setting H-00, we select a number, for
example, H-15, this would amount to producing a
regeneration every 15 days, regardless of the treated
water.
This option is only advisable in installations where
water consumption is not daily, for example, in a
second residence where water entrance to the
installation remains open.
9
5-10
H-30
H-00
EN